Visual Circuits ReelTime 4 Manual de servicio descargar pdf (Pagina 35)

3: Operating the Projector

CHRISTIE INC. CHRISTIE INC. - - 35/70 Service/PM Manual

July, 1997

G2: The SELECT FRAME RATES Commands [DX]

This diagnostic command allows entry of the selected frame rate and the number of perfs per frame. Default values are 30

fps and 5 perforations unless specified otherwise. When using 35mm film select 5 perforations.

ENTRY:

<CMD-G>, <2>

CODE:

INPUT:

1. Select the frame rate:

• Enter a 2 from the keypad to select 24 frames per second

• Enter a 5 from the keypad to select 25 frames per second

• Enter a 3 from the keypad to select 30 frames per second

• Enter a 4 from the keypad to select 48 frames per second

• Enter a 6 from the keypad to select 60 frames per second.

2.Select the number of film perfs:

• Enter a 5 from the keypad to select 5 perfs.

• For models equipped with 8-perf capabilities, enter an 8

from the keypad to select 8 perfs.

ACTION

1.Reset frame rate and number of perfs.

2.Display frame rate in the second- and third-last positions on

the LED display, as shown in Figure 2.3.

3.Display number of perfs in the last position on the LED

display, as shown in Figure 2.3.

STATUS:

Unchanged.

5 perfs30 fps

SEC

FRS

MIN

HRS

Figure 2.3: SELECT FRAME RATES LED Display

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 110 111

Sin comentarios

Visual Circuits ReelTime 4 Manual de servicio Pagina 35