Visual Circuits ReelTime 4 Manual de servicio descargar pdf (Pagina 27)

3: Operating the Projector

CHRISTIE INC. CHRISTIE INC. - - 35/70 Service/PM Manual

July, 1997

H3: The FAST FORWARD Command [DX,L]

This diagnostic command moves the film in a forward direction at a rate of 120 fps. The douser is closed.

This command must be followed by a STOP command, or the film will run off the reel.

ENTRY:

<CMD-H>, <3>

CODE:

ACTION

Move film forward at 120 fps.

STATUS: Set to 8.

H4: The SET FRAME COUNTER Command [DX]

This diagnostic command allows the user to load a new value into the frame counter. The command should only be used

if there is a problem with the current value.

ENTRY:

<CMD-H>, <4>

CODE:

INPUT:

1.Enter the new value for the frame counter in the counter

format hh:mm:ss:ff (see Section 0).

2.Press <ENTER> .

ACTION

Set the frame counter.

STATUS:

Unchanged.

H5: The SET CURRENT SHOW Command [OP]

This operational command causes a display of the current show and the next show in the two rightmost digits of the

numeric display, respectively. The user may enter a new current show number, if desired. The new value must be a valid

show number. The current show and next show values are displayed for one second before the numeric display reverts to

the frame counter. The new current show value must be entered while the show values are displayed.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 110 111

Sin comentarios

Visual Circuits ReelTime 4 Manual de servicio Pagina 27