Visual Circuits ReelTime 4 Manual de servicio descargar pdf (Pagina 22)

2. General Description

CHRISTIE INC. - 35/70 Service/PM Manual

July, 1997

ENTRY:

<CMD-C>, <9>

CODE:

ACTION

Reset the frame counter.

STATUS:

Unchanged.

CA: The READY Command [OP]

This operational command initiates the READY sequence.

When the projector is in READY mode, if the <READY> key is pressed again, the LED

display strip displays the reel counter. To return the show counter to the display, enter

a G1 (DISPLAY COUNTER) command.

ENTRY:

<READY>

CODE:

ACTION

1.Apply power to motor systems.

2.Check all limit switches.

3.Check the CV, Pulldown, and Shutter motor systems.

4.Set loop.

5.Execute single frame advance and stop.

STATUS: Set to 0.

CB: The NOT READY Command [OP]

This operational command places the system in a NOT READY state. When in this state, the projector will not

accept any commands that require film motion.

ENTRY:

CODE:

ACTION

1.Remove power from motor systems.

2.Reinitialize software values and turns the AUTO DOUSER

command off .

3.Reset LED error indicators.

STATUS: Set to B.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 110 111

Sin comentarios

Visual Circuits ReelTime 4 Manual de servicio Pagina 22